Overview

Atmel-ICE is a powerful development tool for debugging and programming Atmel ARM® Cortex®-M based Atmel SAM and AVR® microcontrollers with on-chip debug capability.

Key Features

• Supports JTAG, SWD, PDI, TPI, aWire, SPI and debugWIRE interfaces
• Full source-level debugging in Atmel Studio
• Supports all built-in hardware breakpoints in the target microcontroller (number depends on the OCD module in the target)
• Up to 128 software breakpoints
• 1.62 to 5.5V target operation
• USB powered
• Provides both ARM Cortex Debug Connector (10-pin) pin-out and AVR JTAG connector pin-out

Supported Software

• Perfectly supports Atmel Studio 6.2 or higher version
• Directly supports ICC8AVR or higher version
• Supports programming HEX files generated by ICCAVR, CVAVR, IAR, etc.

Supported Devices

• Programming and on-chip debugging of all Atmel AVR 32-bit MCUs on both JTAG and aWire interfaces
• Programming and on-chip debugging of all Atmel AVR XMEGA® family devices on both JTAG and PDI 2-wire interfaces
• JTAG and SPI programming and debugging of all Atmel AVR 8-bit MCUs with OCD support on either JTAG or debugWIRE interfaces
• Programming and debugging of all Atmel SAM ARM Cortex-M based MCUs on both SWD and JTAG interfaces
• Programming of all Atmel tinyAVR® 8-bit MCUs with support for the TPI interface

For more details, please visit http://www.atmel.com/tools/atatmel-ice.aspx?tab=devices

Specifications

Physical Interfaces

Atmel-ICE Connection Options

Note : While connecting the adapter board to a target, please pay attention to the Pin 1 (indicated by white spot or square solder pad).

① 10-pin AVR JTAG header

② 6-pin AVR ISP/debugWIRE/PDI/aWire/TPI header

SPI/debugWIRE

PDI

aWire

TPI

10-pin AVR ISP header is also available through our extra free 6-pin to 10-pin ISP cable

③ 10-pin SAM JTAG/SWD header

Development Resources

Wiki : www.waveshare.com/wiki/Atmel-ICE